WHAT'S IN THE KIT:
- 2 – Long Grip Pins
- 3 – Short Grip Pins
KEL-TEC SUB-2000 Gen 3 Grip Pin Upgrade Kit
Replace your factory aluminum grip pins with M*CARBO's carbon steel upgrade – designed exclusively for the Gen 3 SUB-2000. Built for strength and precision. It’s carbon steel on carbon steel – exactly how it should be.
Enhance the structural integrity of your Gen 3 SUB-2000 polymer grips. If you've ever experienced screws backing out of soft aluminum pins, this upgrade provides the long-term solution. The kit includes 2 long pins and 3 short pins to fully replace your factory set.
Each pin is finished in black oxide for corrosion resistance and a tactical, low-glare appearance that blends seamlessly into your firearm. Compatible with the Gen 3 SUB-2000 model only.
Note: These pins are engineered for Gen 3 hardware tolerances. For best performance, pair them with the M*CARBO Carbon Steel Screw Kit.
Still running factory pins? Take a look at the hinge pin on your rear iron sight—bright, reflective, and prone to wear. Our black oxide grip pins provide a sleeker look, greater durability, and a fully color-matched upgrade designed for your Gen 3.
KEL-TEC SUB-2000 Gen 3 Resources
Planning a full Gen 3 upgrade? Use these SUB-2000 resources to make your project easier:
Owner's Manual
Exploded View
Tested and Approved:
The KEL-TEC SUB 2000 Gen 3 Grip Pin Upgrade Kit has been tested repeatedly to ensure reliable operation and safety.
ATTENTION:
You must be 18 yrs of age to purchase. We advise that all parts purchased from our inventory be installed and inspected by a qualified gunsmith. Modifying your weapon may be prohibited in your state. Do not modify your sear or hammer engagement surfaces, with or without the KEL-TEC SUB 2000 Gen 3 Grip Pin Upgrade Kit. Before installing please be sure to check all local state and federal laws. By installing this part you agree to take full responsibility for any and all legal, health and warranty consequences that may be incurred.
Why is there no screws included in this kit ?
Will this work with the gen 3 10mm
No - These do not fit the 10mm
Do these fit GEN 3 5.7 x 28 edition?
No they don't work. I just bought a set and tried them on my Keltec 5.7 Gen 3. They are not the same size. Hope I can return them.
Answered by
/
September 2, 2025 11:52 AM
No they don't work. I just bought a set and tried them on my Keltec 5.7 Gen 3. They are not the same size. Hope I can return them.
Answered by
/
September 2, 2025 11:51 AM
No they don't work. I just bought a set and tried them on my Keltec 5.7 Gen 3. They are not the same size. Hope I can return them.
Answered by
/
September 2, 2025 11:51 AM
Do these fit GEN 3 5.7 x 28 edition?