Need assistance? Call our experts: (727) 223-1816 or visit support.mcarbo.com
Great part. Top quality.
Quit shooting my Ruger PCC for Speed Steel because of excessive stovepipes. This item fixed the problem - look out next Speed Steel Match.
Ordering and Delivery: Easy, good price, quick, correct product and on-time.
Quality: Appears to be well built. MUCH better than the OEM that came with the PCC. Extra "hook" appears efficient.
Installation: Easy since I usually remove the extractor when doing a major teardown cleaning anyway. If you don't know how then you are probably not cleaning that PCC enough and there is plenty of installation help on-line.
Results: Fired about 100 rounds during testing and training. Even my lighter recoil ammo was successfully extracted. Brass was thrown a lot farther than with the OEM Extractor - even when new.
Overall: So far an excellent product and a great vendor. Well satisfied, I will use them again.
Fixed the ejection problem of stovepipe. Good product
Great part! Well machined and fits like a glove. Installation was quick and easy...maybe 5 minutes! Thanks much M*CARBO!!!
Was having occasional failures to eject with ETS 30 round Glock mags. I changed the extractor and now after 150 rounds through Glock & ETS magazines there are no issues.
great product, solves ejector stovepipe issue
I bought a Ruger carbine second hand and it was immediately having issues. If I ran a mag of 10 rounds through it, about a third of them would fail to eject. With hollow points, if I got two rounds to feed consecutively it was a lot. Tried both Ruger and Glock mags.
Replacing the OEM extractor with this one solved the issue and the gun shoots lights out now.
So far so good. 100 rounds without any issues. Will know more after a few more range trips and 3 guns. Old extractor was rounded on one side.
I was getting many FTE/stovepipes on a new Ruger PC Charger on almost every magazine (Glock 15 & 17 rd). I read around that this was an issue for many people (but tended to break in over time). However, bought this extractor, easily installed, and haven't had one single failure since installation (couple of hundred rounds, same mags). Excellent product, raised my confidence level in using this gun for home defense a lot!
The Ruger PC Charger is one of the most enjoyable, fun guns to shoot that I own. Unfortunately, it was not fun when out of the box there were numerous stovepipes and extraction problems through the first range session of 500 rounds with several different mags and four types of 9mm ammunition. The M.Carbo Exact Edge Extractor was easy to install and the next range session there were NO stovepipes and NO extraction issues through 300 rounds. I also installed the A2 Tool Steel Bolt Heads, Shock Buffer, and Steel Spring Retainer at the same time for good measure. The Shock Buffer does feel like a more controlled recoil, although I did not do a back to back test. All around these are great products that make the gun run as it can and should. I don't regularly write reviews, but I like the M.Carbo products and especially the attitude. USA made, fair prices, excellent install vids if needed, fast shipping, etc.
Get this you will see the difference.
Have many M-Carbo parts on my PC Charger and Sub 2000, all great products.
Easy install, and the factory becomes a spare(still might buy another).
Submitted two types of credentials (several times) AND still no discount. Got an email to review shipping(so i did) nothing much back in the response. Part is as described.
Replaced OEM part that was showing wear.
This is a huge improvement over the stock one that comes in it the gun.Also added a Franklin Armory bfsiii pc-c1 binary trigger and with the increased cyclic of fire figured this was cheap insurance just in case.
Literally have everything that can be added to the Charger pistol between mcarbo F/A and tk.Got to say this is a fun little pistol.